Rainscreen curves

Instead of modeling only the 8 foot section (with one curve) I continued the curve in both directions (left-right, up-down); so the grasshopper model is 24′ x 24′.  I did this because I was curious to see how the end points for the middle 8′ section would change the curve as it continues on into the next section. Although it was a slight change, it is a change that would alter the structure holding the screen at that point.


I’m working on extending the surface across the entire 24’x24′ grid.  I used the edge surface for the small section but that won’t work with the larger one.  I need one surface to go across the whole grid following each curve in the middle.

Advertisements
This entry was posted in Rainscreen, Rhino/Grasshopper. Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s